AppleWin v1.31.0.0 is released. AppleWin (also known as Apple //e Emulator for Windows) is an open source software emulator for running Apple II programs in Microsoft Windows. AppleWin has support for most programs that could run either on the Apple II+ or the Apple IIe. By default, AppleWin emulates the Extended Keyboard IIe (better known as the Platinum IIe) with built-in 80-column text support, 128 kilobytes of RAM, two 5.25-inch floppy disk drives, a joystick, a serial card and 65C02 CPU. AppleWin supports lo-res, hi-res, and double hi-res graphics modes and can emulate both color and monochrome Apple II monitors; later versions of AppleWin also can emulate a television set used as a monitor. Both 40-column and 80-column text is supported.

AppleWin can emulate the Apple II joystick (using the PC's default controller), paddle controllers (using the computer mouse), and can also emulate the Apple II joystick using the PC keyboard. AppleWin can also use the PC speaker to emulate the Apple II's sound if no sound card is available (does not work under NT-based Windows versions). Full screen mode is available through the use of DirectX. Features added to the latest versions of AppleWin include Ethernet support using Uthernet, Mockingboard and Phasor sound card support, SSI263 speech synthesis, hard drive disk images and save states.

AppleWin Changelog:
[Change #1392, #1423] Add a 64-bit version of AppleWin to the distro: AppleWin-x64.exe (beta).
[Change #451] Debugger: Support address prefixes for breakpoints and Mini mem dump window:
bp or bpm[r|w] [s/][/][l<1|2>/][rom/]
Similar for m<1|2> commands.
Additionally inspect Mockingboard state: m<1|2> s/
Extend the UI to show specifics of memory bank number & LC 4K bank 1 or 2.
Extend the 'bpl' command (Breakpoint List) to include the full address prefix.
See AppleWin.chm help doc, Debugger: Breakpoints & Memory sections.
NB. divide operator changed to '//'
[Change #1416] Mockingboard and Phasor cards now default to SSI263AP (instead of older SSI263P).
mb-audit 1.57 (and earlier) will now fail the Phasor/SSI263 reset test: "43:F1:00, Expected:02 Actual:00".
Restore the old AppleWin behaviour with, eg. '-s4 socket1=ssi263p' for the SSI263 at $C440.
NB. mb-audit 1.58 supports both the SSI263P & SSI263AP for this Phasor/SSI263 reset test.
Add command line to add/remove SC01: -sN .
[Change #1421] Debugger: reduce start-up console output, and add new 'log' command.
[Bug #1428] Fix issue when changing Apple II model where aux slot became empty (regression at 1.30.21).
[Bug #1414] RamWorks III: Power-cycle now resets to bank 0.
[Bug #1412] SSI263: Chip power-down not silencing continuous phoneme (regression at 1.30.21).
[Bug #1407] Mute any sound when right-context (pop-up) menus are shown.

Download: AppleWin v1.31.0.0
Source: Here